HIGHSIDER pro 5 3/4 inch LED headlight insert TYPE 6, E-approved
This round, chrome-plated reflector features high beam, low beam, daytime running lights, and a parking light ring. The daytime running light is located in the center of the strip, and the low beam is located in the upper half of the insert. When the high beam is on, both halves are illuminated.
Our highlights – give your bike your own unique style! The striking design and perfect technology of the HIGHSIDER pro headlight series will definitely make your bike a standout!
Size:
Diameter A = 143 mm
Diameter GA = 133 mm
Diameter I = 131 mm, T = 70 mm, R = 13 mm
Cable length: 400 mm
Power consumption: (3 pin connector)
Connections:
White = low beam (+)
Blue = high beam (+)
Green = Ground (-)
Red = DRL (+) to ignition plus
Brown = Position light (+)
Scope of delivery: 1 piece including 1x connector housing
Note:
Daytime running lights can also be used on vehicles without a light switch. The following components are required for this:
• Order No.: 240-044 LIGHT ON/OFF SWITCH
• Part No.: 208-108 HIGHSIDER pro DRL CONTROL- BOX CB1 (switches between low beam and daytime running light)
Note:
Should the headlight fail to activate daytime running lights after starting the engine when used with this product in conjunction with the HIGHSIDER pro DRL CONTROL-BOX CB1 (208-108), please proceed as follows:
Install the enclosed 120 Ohm resistor as described in the instructions.
Now the headlight should also switch on the daytime running lights.
